Advanced Usage

JetKVM Mini recovery

Recovery writes the latest firmware to the Mini over USB. Use it when the Mini doesn't start, or is stuck before it shows an IP address. Your settings and the images on the TF card are kept.

You need a computer and a USB-C cable that carries data, not only power.

Install in the browser

The JetKVM installer downloads the latest firmware and writes it to the Mini from your browser. It also has an option to clear the settings.

Which JetKVM Mini do you have?

Each model has its own firmware. The other model's firmware won't start.

Install from the command line

Use these steps if the installer does not work in your browser, or if you prefer the command line.

Download the recovery image

Pick the image for your model. JetKVM Mini W is the wireless model, with no Ethernet port.

Use the image for your model. The other one won't start on your Mini.

Connect the Mini to your computer

  1. Unplug the Mini from the target computer.
  2. Connect the Mini's general-purpose USB-C port, marked EXT, to your computer. It powers the Mini at the same time.

Flash the image

Install Espressif's esptool with Python, then write the image from the folder you downloaded it to. esptool finds the Mini on its own.

Terminal
pip install esptoolesptool --chip esp32p4 write-flash 0x0 jetkvm-mini-full.bin

Restart the Mini

  1. Unplug the cable and plug the Mini back into the target computer.
  2. Wait for the display to show the IP address. Recovery is complete.

Start over with no settings

To erase the settings and the Mini's internal storage too, run esptool --chip esp32p4 erase-flash before step 3. Then flash the image as usual, and set the Mini up again. Images on the TF card are still kept. In the installer, turn on Clear settings instead.